SV: PCB's arrived Friday. It Works

["Ake Hedman" <akhe@xxxxxxxxxxxxx>]

**Very** nice work!!!

Will this be closed work or will you share code, schematics?

Regards
/Ake
-----Ursprungligt meddelande-----
Fran: Ian Davidson [mailto:ian@xxxxxxx]
Skickat: den 20 juni 2004 22:30
Till: ukha_d@xxxxxxx
Amne: [ukha_d] PCB's arrived Friday. It Works


Hi All

Well after many delays I finally had a fully working prototype of my X10
replacement. I took the plunge and ordered 20 PCB's which arrived on
Friday.
I build one up on Friday and have been testing it as I got chance this
weekend. As of about ten minutes ago it all works. I have one built and
boxed sat on the hall floor ( SWMBO gone out to work). I can set the light
to any value and currently have a fan connected to the AUX o/p all
switching
as it should. Full status is working, I know the current level and if in a
dim cycle what level it is getting to. I can see the switch status and
receive a message when the switch is pressed either on or off. I have
added
a few more pictures to

http://www.automated-house.co.uk
<http://www.automated-house.co.uk/>

Click on gallery and forward to the first picture with some PCB's and a
pint
pot! There are about a dozen pictures from there on.

I have not updated any of the text yet but I will do as I get the chance.

The last part of the puzzle is to integrate them into my HA setup. I was
going to try to write a homeseer plugin, however XAP/XPL have both come on
and I believe now support homeseer. So can anyone from the XAP/XPL groups
tell me how I could write a PC app that would enable my modules that
communicate in a form of SNAP (the packet size is between 11 and 15 bytes
depending on the address field size) to talk either XAP/XPL. Ideally one
that is based around a file so that I could add extra commands as
required.
I have one command byte so I could specify command 04 which is a goto
level
command and then add the appropriate XAP/XPL details. Is there anything
available I could modify. Unfortunately I do not have VB my test software
I
wrote in Delphi, so any help appreciated.

OK enough typing must get back to some more testing.

Ian D




[Non-text portions of this message have been removed]