RE: [OT] Hole cutting

[Frost Neil <Neil.Frost@xxxxxxx>]

You could then use a normal cold chisel etc or sds+ / kango hammer drill
to
create a square hole the right size. Once the vent etc is in place,
simply
fill the gaps with a mortar-like (or just sand and cement) and re-render
and
paint / pebble dash whatever......

Neil

-----Original Message-----
From: Dave McLaughlin [mailto:dave@xxxxxxx]
Sent: 28 October 2002 14:16
To: ukha_d@xxxxxxx
Subject: Re: [ukha_d] [OT] Hole cutting


The area I need to drill is rendered and I believe that it is breeze
block
underneath.

Dave...

----- Original Message -----
From: "Frost Neil" <Neil.Frost@xxxxxxx>
To: <ukha_d@xxxxxxx>
Sent: Monday, October 28, 2002 1:39 PM
Subject: RE: [ukha_d] [OT] Hole cutting


> Is it brick or render on the outside?
>
> -----Original Message-----
> From: Dave McLaughlin [mailto:dave@xxxxxxx]
> Sent: 28 October 2002 13:37
> To: ukha_d@xxxxxxx
> Subject: [ukha_d] [OT] Hole cutting
>
>
> Hi All,
>
> I need to cut a large diameter hole in my utility room wall to the
outside
> to vent the tumble drier.
>
> Any ideas of where I can hire this sort of gear or buy at low
cost..?
>
> I recon I need about a 100mm dia hole or thereabouts.
>
> Thanks
> Dave...



http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx 
Subscribe:  ukha_d-subscribe@xxxxxxx 
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
List owner:  ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

Yahoo! Groups Sponsor

ADVERTISEMENT

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx 
Subscribe:  ukha_d-subscribe@xxxxxxx 
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
List owner:  ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.