The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [OT] Hole cutting



Thanks Neil and Tracey.

Checked out A-Plant and I can get a drill and diamond tipped bit for about
40-50 quid for the weekend including the wear charge. I assume a small wear
with breeze block?

Dave...

----- Original Message -----
From: "Frost Neil" <Neil.Frost@xxxxxxx>
To: <ukha_d@xxxxxxx>
Sent: Monday, October 28, 2002 2:20 PM
Subject: RE: [ukha_d] [OT] Hole cutting


> You could then use a normal cold chisel etc or sds+ / kango hammer drill
to
> create a square hole the right size. Once the vent etc is in place, simply
> fill the gaps with a mortar-like (or just sand and cement) and re-render
and
> paint / pebble dash whatever......
>
> Neil


Yahoo! Groups Sponsor
ADVERTISEMENT

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/


Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.