The UK Home Automation Archive

Archive Home

Group Home

Search Archive
Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Cable for IR distribution

To: "Home automation \(E-mail\)" <ukha_d@xxxxxxx>
Subject: Cable for IR distribution
From: "Nikola Kasic" <nikola@xxxxxxx>
Date: Mon, 15 Jul 2002 02:43:12 +0100
Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
Reply-to: ukha_d@xxxxxxx

Although I'll not implement it yet, it's time to lay the cables down...

I would want to be able to have remote in each room and devices as well.

So I asume that I'll need IR sender and IR receiver in each room.

Will I need one Cat5 cable to each, or I can use the same cable for sender and receiver.

Again, does it have to be shielded, and is Cat5e fine?

Regards,

Nik

Yahoo! Groups Sponsor

For more information: http://www.automatedhome.co.uk Post message: ukha_d@xxxxxxx Subscribe: ukha_d-subscribe@xxxxxxx Unsubscribe: ukha_d-unsubscribe@xxxxxxx List owner: ukha_d-owner@xxxxxxx Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. Prev by Date: RE: CAT5e in New House Ads Next by Date: Re: BT cabling through patch panel Previous by thread: RE: IR remote control extender circuit Next by thread: NOW Automated Vacuum WAS First post Index(es): Date Thread Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.