RE: Homevision expansion board

["Future-Homes" <paul@xxxxxxx>]

thanks mike will try this

-----Original Message-----
From: Mike Griffiths [mailto:mike@xxxxxxx]
Sent: 23 February 2002 10:13
To: ukha_d@xxxxxxx
Subject: RE: [ukha_d] Homevision expansion board


Paul
There is also an issue with induced signals where the different Zones run
close to each other where they enter the expansion case
Try separating the wires a bit and see if this helps

There was a thread about this about a year ago on the HomeVision group

Mike
At Home


-----Original Message-----
From: Future-Homes [mailto:paul@xxxxxxx]
Sent: Sat 23 Feb 2002 08:34
To: Newsgroups
Subject: [ukha_d] Homevision expansion board

Does anyone else get problems with the 8 zone IR output board on
Homevision.
I have 3 amps and 2 video's all with the same IR codes each on different
zones. When I run a certain macro intended for one amp its fine ie
selecting
an input but if I run a similar macro on the other amp 2 amps respond
together again switching inputs. 3 amp is great and has no effect on the
other 2 when used. Seems IR is bleeding across zones,have tried all sorts
of
combinations and IR leads but still no joy. Does anyone have any ideas?? 3
amps are all sony.

Cheers

Paul



For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/



For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/