The UK Home Automation Archive

Archive Home

Group Home

Search Archive
Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Running RS232 over Cat5

To: <ukha_d@xxxxxxx>
Subject: Running RS232 over Cat5
From: "Paul Gale" <groups@xxxxxxx>
Date: Sat, 7 Dec 2002 11:35:59 -0000
Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
Reply-to: ukha_d@xxxxxxx

I'm just about to run several RS232 signals over Cat5. Does it make a difference if I use a pair for the RX/TX or not i.e. should the RX/TX be twisted? Paul. [Non-text portions of this message have been removed]
http://www.automatedhome.co.uk Post message: ukha_d@xxxxxxx Subscribe: ukha_d-subscribe@xxxxxxx Unsubscribe: ukha_d-unsubscribe@xxxxxxx List owner: ukha_d-owner@xxxxxxx List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

Follow-Ups:
- Re: Running RS232 over Cat5
  - From: justin@xxxxxxx

Prev by Date: Re: Re: New hw Dev Kit
Next by Date: Re: New hw Dev Kit
Previous by thread: Re: New hw Dev Kit
Next by thread: Re: Running RS232 over Cat5
Index(es):
- Date
- Thread

Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.