Re: Lights switching by themselves

["garygfx" <garygfx@xxxxxxx>]

I'm using Comfort defaults and it appears to turn on/off one of my 
lights at roughly the same time each night. I haven't been able to 
find the Responce that's responsible for this yet, but if you unplug 
the RS232 interface from Comfort for 24h you can tell if it's 
Comfort's fault or not.

If not then are you using any MS13 PIR sensors? I had this problem 
when it gets dark it send an on signal to the next unit address so a 
light goes on. Then because it's bright it sends out the off signal. 
Then because it's dark it sends out the on signal, etc, etc.

Gary.


--- In ukha_d@y..., "billybc_98" <billobrien30@h...>
wrote:
> Hi,
> 
> I have recently rewired and included 10 x LD10's for light control.
I 
> also have a comfort Alarm with X-10 interface - at the moment 
comfort 
> X-10 settings are all at factory defaults.
> 
> I am experiencing lights coming on and going off by themselves. It
> does not appear to be restricted to any particular room/ld10 unit.
> 
> I have tried switching eveything to a new house code (from A -> M)
> but the problem persists.
> 
> Do I need a whole house filter ? 
> I've read about line level filters in the US. Will one of these 
work 
> and where can I get it ?
> 
> OR do you think it is coming from an internal source.
> Any help appreciated.
> 
> Sorry if this has already been discussed, I seached but could not 
> find.
> Bill O'Brien

Yahoo! Groups Sponsor

ADVERTISEMENT

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx 
Subscribe:  ukha_d-subscribe@xxxxxxx 
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
List owner:  ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.