[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
Re: Wall Switches for AD10 & LD10/11
- To: ukha_d@xxxxxxx
- Subject: Re: Wall Switches for AD10 & LD10/11
- From: richard.lockyer@xxxxxxx
- Date: Fri, 04 May 2001 12:22:28 -0000
- Delivered-to: rich@xxxxxxx
- Delivered-to: mailing list ukha_d@xxxxxxx
- Mailing-list: list ukha_d@xxxxxxx; contact
ukha_d-owner@xxxxxxx
- Reply-to: ukha_d@xxxxxxx
I use AD10s for contolling low-energy flourescent lights with
standard light switches. The only slight niggle is that if the
switch is off and you have turned on the light with X-10, you have to
switch the switch on and then off to turn the light off (and vice
versa).
SWMBO complains about this sometimes!
Richard
--- In ukha_d@y..., "Steve Cooper" <steve.cooper@u...>
wrote:
> Folks
>
> Just getting into all this automation game, so this is a bit of a no
> brainer question but that's what your out there for I suppose.
>
> I understand that a LD11 needs a momentary (push to make) switch to
operate
> but I have seen articles that seem to imply the AD10 can use either
push to
> make or make-break (standard) wall switches. Question is what
should I be
> using for the AD10 which is controlling some fluorescent lights?
Any
> recommendations for the best places to get hold of momentary
switches, DIN
> rail enclosures and the bits like are also more than welcome?
>
> Cheers
>
> Steve
Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
Home |
Main Index |
Thread Index
|