RE: Sky''s the limit :-(

[Steve Morgan]

Go into Services/System Settings/Picture - as has been suggested
previously,
I bet the Video Output is set to RGB. Change this to Composite and I think
you'll find it springs into life.

Steve

> -----Original Message-----
> From: tefxp [mailto:<a
href="/group/kat5-users/post?postID=gylJb8uLNjO_tWJzienRejvaG0mfMcISEBPbmZORX4cVbd2Xm5uHyw9DWD1HVVkSudjtNcqLCFJh_Q">Tony.BUTLER@r...</a>]
> Sent: 22 January 2002 19:27
> To: <a
href="/group/kat5-users/post?postID=gMDRMb9GyGxH5S4NLc5QqqbUna78rK1yrDnP_1xoD8vteEXdGE50yG_qh_BaeywkQzNsNWOmhsHLzA6U_XdWY1c">kat5-users@xxxxxxx</a>
> Subject: Re: [KAT5] Sky's the limit :-(
>
>
> > I conencted the sky box directly to a flat panel LCD &amp; no
joy
> there either,
> > but in fairness, I have never connected anything other than a PC
> to it, so I
> > can't say for definite that I had the LCD configured correctly.
>
> Well, I connected a bog standard VCR to the KAT5 units and then
> though to my LCD monitor and it works fine as a composite signal.
>
> I connected the SKY box again to this setup and..... dead as a
> doornail.
>
> So, No Kat5 &amp; Sky box is absolutely fine.
> Kat5 it up and no piccie :-(
>
> Perhaps the SKy box levels are a bit low &amp; the Kat5 is
introducing
> just enough noise that neither the LCD panel nor the TV can detect a
> signal - is there any way to boost the output or something?
>
> I want to continue to run everything thru my amp so something that
> works for Sky but not for the other devices won't be much use :(
>
> Heellpppp!!
>
> Tony