[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

which x10 transceiver module to use?

Subject: which x10 transceiver module to use?
From: arnie <parvezat6@xxxxxxxxxxxxxx>
Date: Wed, 04 Jul 2007 00:23:55 -0700
Newsgroups: comp.home.automation

I have a PowerLinv V2 controller [USB] with 2 insteon signal linc
connected in each phase of 110V/50Hz in a 2-single phase connections.
There are x10 lamp module [LM465] along with motion sensor MS14A set
to the house code of lamp module. The motion sensor is working by
turning on the lamp module when any motion is detected but the PLC is
not getting any feedback corresponding to the motion sensor activity
Is the motion sensor working with the aid of signal linc.
What x10 transceiver module can i make use of in conjunction with
sensor
Thanks
Arnie

Follow-Ups:
- Re: which x10 transceiver module to use?
  - From: Dave Houston

Prev by Message: Re: reterive status of x10 devices using c#
Next by Message: Re: which x10 transceiver module to use?
Previous by thread: Re: HVAC Actuator controls (4-20mA or 0-10V?)
Next by thread: Re: which x10 transceiver module to use?
Index(es):
- Message
- Thread

comp.home.automation Main Index | comp.home.automation Thread Index | comp.home.automation Home | Archives Home