Re: RG6 to RJ45

["dpw" <dpw168@xxxxxxxxx>]

ABLE_1 thanks for your reply.  Went to their site and did not see
solution there.  Could you give me more detail on what product they are
supposed to carry?

To explain more, fellow tech called me about a job he is on where an
electrician ran network cable in new house.  2 Problems: he ran Cat3
instead of Cat5e or Cat6 and now the walls are all closed up.  The one
thing he did do was run a lot of excess RG6 drops.  And a few months
ago I read about these wall plates that can convert RG6 to RJ45.  The
article may have been in Residential Systems Magazine or SCN (System
Contractor News).  I have not found the back issue yet.

Thank You.




ABLE_1 wrote:
> http://www.nvt.com/
>
>
>
>
>
> "dpw" <dpw168@xxxxxxxxx> wrote in message
> news:1163194000.081470.185250@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> > Short time ago read an article about a new product that would allow an
> > RG6 connection to be converted to RJ45 jack.  Allows unused RG6 runs to
> > be transformed to network use at the wall plate.  Similar transceiver
> > would convert cable at termination point.
> >
> > Does anyone know the company that manufactures these?
> >
> > Thank You.
> >