[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: Finishing basement, suggestion on RG6 cable needed

Subject: Re: Finishing basement, suggestion on RG6 cable needed
From: "Bill Kearney" <wkearney99@xxxxxxxxxxx>
Date: Sun, 29 Jan 2006 14:11:41 -0500
Newsgroups: comp.home.automation, comp.dcom.cabling
References: <4l2it197k9s4l6k0cusvcg19tmo2b8f3o0@xxxxxxx> <Xns97598558AA129idispcom@xxxxxxxxxxxxxx>

> I concur, conduit is one of the best ideas.

I'll third that motion.  If you don't run conduits to each location then at
least run it between major distribution points.  Like a 4" riser going from
the basement to the attic (or a pair of 3-inchers).  This way you at least
have a clear shot and getting more stuff pulled between the hard places.

References:
- Finishing basement, suggestion on RG6 cable needed
  - From: BIOSMonkey
- Re: Finishing basement, suggestion on RG6 cable needed
  - From: DanS

Prev by Message: Re: Trash-Bot
Next by Message: Re: ADI SpeakEasy (was Re: Suggestions wanted for Motion Detector delay/time-out)
Previous by thread: Re: Finishing basement, suggestion on RG6 cable needed
Next by thread: Re: Finishing basement, suggestion on RG6 cable needed
Index(es):
- Message
- Thread

comp.home.automation Main Index | comp.home.automation Thread Index | comp.home.automation Home | Archives Home