Re: X-10 RF Freq Mod

[Just Another Joe <address@xxxxxxx>]

On Wed, 20 Dec 2006 01:06:26 GMT, nobody@xxxxxxxxxxxx (Dave Houston)
wrote in message <45898af4.384715000@xxxxxxxxxxxxx>:

> With Palmpads, etc. you can disable the X-10 transmitter circuit (single
> transistor) and send the data signal to one of the 4-pin transmitters if you
> can fit it inside the case. You can use a short flexible wire as the
> antenna.
>
> A simple way to handle multiple frequencies with roZetta will be to use an
> MR26A (310MHz) and MR26E (433.92MHz) on separate serial ports. However, you
> would need European versions of the palmpads and their power output is
> higher than FCC (or Industry Canada) rules allow.

Are the European versions of the motions sensors also higher powered?  I
don't know which would be cheaper to replace, a handful of sensors or a
handful of palmpads.  Either way, one would also need to get the
European MR26E.  I wouldn't know how to get the European versions here,
and likely wouldn't do so anyway, if their operation here would be
considered illegal.

--
Just Another Joe        Remove .windows to reply.
Why be politically correct, when you can be right?