Re: Coax tools

["Bill Stock" <Me7@xxxxxxxxxxx>]

"BruceR" <razrbruce%NOSPAM%@xxxxxxxxx> wrote in message
news:fw1Ze.90$556.65@xxxxxxxxxxxxxxxxxxxxxxx
> There are specific connectors for RG-59, RG-6 and RG-6QS. Be sure to use
> the right one. Are you properly stripping the cable and inserting it
> fully?

These are the connectors
http://200.78.227.133/catalog/products_desc.asp?fam=1&sfam=1&item=3&mv=200-032&cuenta=3&posicion=3

and the cable is RG-6 (satellite cable).

I was wondering about the insertion, but I'm using a standard coax stripper
set to the defaults. Plus the ferrule compression is well above the swell
point on the cable insertion.

> From:Bill Stock
> Me7@xxxxxxxxxxx
>
>> I bought one of the fancy compression crimping tools for use with the
>> PermaSeal connectors. But it did not come with much in the way of
>> instructions. I thought I had it figured out, but the connectors just
>> pull right off after being compressed.
>>
>> There can't be any mystery to this, so my cable must be too small?
>> (Insert joke here)
>>
>> Any advice appreciated.
>
>