[no subject]

You will need to do this every time you move the PIM from the Upstart PC to
the Omni.

Regards,
Dan


"Mark Thomas" <mrt@xxxxxxxxxxxxxx> wrote in message
news:1117566204.803097.244180@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>
>
> oren levy wrote:
> > Hi,
> >
> > I have OmniLT with 10A17-1 serial module. I connected the Omni
> > to the X-10 and it works fine. I also bought the PIM-r. I installed
> > the Upstart and saw the UPB network. Than- I disconnect the PIM-r
> > and connected it directly to the OmniLt (to the serial module).
> >
> > unfortunatlly, the omni recognize the X-10 but didn't recognize the
> > UPb devices.
> >
> > Any suggestions?
>
> Since you have shown that it's not a problem with the UPB devices, you
> should contact HAI (or the dealer). Also, since UPB support is brand
> new, make sure you have the latest firmware (2.9).
>