Re: programming with CM15A & motion sensors

[Joerg <notthisjoergsch@xxxxxxxxxxxxxxxxxxxxx>]

Hello Dave,

>>As Dave said, the sensors are xmit only. But what if you would let the
>>sensor signal start a CM15A macro? Then the event would be captured.
>
> The event is captured when the motion occurs. What does a macro add?

It would be just a kludge. If I understood Paul correctly he was looking
for a chance to see after the fact whether a motion sensor has detected.
IOW when he hasn't captured that event on his PC or elsewhere.

So you could trigger a macro that repetitively "plays" a code for a
while. That way you could catch that code and assume a motion detect
must have occurred within the last x minutes.

Regards, Joerg

http://www.analogconsultants.com