Re: Should be simple but never is, help pls

[nobody@xxxxxxxxxxxx (Dave Houston)]

You might ask your question of the supplier. You would need to gang the
circuits in some manner.

I would definitely avoid the Levitons recommended by others. They use X-10
Hail Acknowledge commands in non-standard ways which is certain to create
problems down the road.

"No" <no@xxxxxxxxx> wrote:

>I actually have bookmarked that page. How can I use these to have multiple
>sensors control multiple circuits?? No way I can think of.
>
>"Dave Houston" <nobody@xxxxxxxxxxxx> wrote in message
>news:430611d8.56315621@xxxxxxxxxxxxxxxx
>> http://www.elights.com/outdoor-motion-sensors.html
>>
>> "No" <no@xxxxxxxxx> wrote:
>>
>>>Hello - I would like to install motion detectors on all 4 sides of my
>>>house.
>>>These motion detectors should only operate dusk to dawn. When motion is
>>>sensed on any of the 4 detectors it should trigger all 5 lighting circuits
>>>to turn on (Or selectable circuits).
>>>
>>>I do not care if its X10 or any other command type solution. I can
>>>probably
>>>run low voltage wire to each switch or light if necessary.
>>>
>>>I do not want batteries in the loop. If a switch replacement is required
>>>it
>>>must be a toggle style, not a decora style. Dimming is not important,
>>>lights
>>>are incandescent.
>>>
>>>I also want the system to be robust and reliable.
>>>
>>>Any suggestions where to look? I've been to smarthome and cant seem to
>>>find
>>>what I need/want.
>>>
>>
>