Re: Scantronic 500r+ reset tamper

[funky-juz_at_hotmail_dot_co_dot_uk@xxxxxxx (JC007)]

JC007 had written this in response to
http://forums.cabling-design.com/security-physical/Re-Scantronic-500r-reset-tamper-48557-.htm
 :
Did you find a successful solution to this issue? I have recently moved
into new house with the 500r, I have also stupidly set off the tamper
alarm on the panel. I am having no luck in resetting it. I have no user
code (previous owner deceased). I disconnected the battery but this set
the external siren off, so that's been reconnected! I have silenced the
panel alarm by unplugging the speaker as a short term fix. Can anyone help
me reset the tamper?

Thanks
Justin


cmp1951 wrote:

> cmp1951 had written this in response to
>
http://www.secure-gear.com/alt.security.alarms/5/Re-Scantronic-500r-reset-tamper-article31914-.htm
>  :

> Notice you state you have an installation guide for the Scantronic
> 500r+.

> I need a copy of said guide - I have (don't kno how) changred a user
> code
> and cannot now use the alarm, since it has been set off and I cannot
> reset
> it.

> I have tried the installer codes and master codes noted in another panel
> manual using the same accessories, but they don't help.

> Not only that, even if they did, I wwouldn't kno what the sequence of
> buttons to press to reset, and recode.

> Mike 106652.3564_at_compuserve_dot_com
> -------------------------------------
> Jim wrote:

>> On Apr 11, 7:59?am, "MyKey"
>> <michaelw...@xxxxxxxxxx>
>> wrote:
>>> Can any alarm gurus out there help a noob out. I've accidently
>>> (stupidly) set off a tamper alarm by removing a detector from
>>> the
>>> wall. How can I reset the detector etc? The user manual says
>>> contact
>>> engineer for service, but I've no idea who installed the alarm.
>>> I
>>> have
>>> a copy of the installation and user guide but need some help to
>>> find
>>> the correct command. Do I need a special engineer code?
>>>
>>> Thanks in advance
>>> Mike

>> I stupidly pulled a plug apart in the engine compartment of my car.
>> How can I reset the check engine light on the dash board. The
>> manual
>> says to bring it to my mechanic, but I don't have a mechanic. I
>> have a
>> copy of the users guide but need some help to find the correct
>> command. Do I need a special engineer code?

>> Duuuuuuuuuh Would it help to know what make model and year, my car
>> is?
>> Duuuuuuu ...... HuH? HUH? Would it?






> ##-----------------------------------------------##
> Delivered via
> http://www.secure-gear.com
> The Internet Knowledge Base for the security industry
> no-spam access to your favorite newsgroup -
> alt.security.alarms - 44250
> messages and counting!
> ##-----------------------------------------------##


-------------------------------------




--
+----------------------------------------------------------+
|            http://forums.cabling-design.com/             |
|              *** a better way to USENET ***              |
| no-spam Web and RSS interface to your favorite newsgroup |
|    alt.security.alarms - 55290 messages and counting!    |
+----------------------------------------------------------+