Re: Replacing Radionics with Vista 20P

[Jim Rojas <jrojas@xxxxxxxxxxxx>]

mleuck wrote:
> On Jan 30, 7:13 pm, Frank Kurz<t...@xxxxxxxxxxxxx>  wrote:
>> On 29/01/2011 6:39 PM, mleuck wrote:
>>
>>
>>
>>
>>
>>
>>
>>
>>
>>> On Jan 29, 7:11 pm, Frank Kurz<t...@xxxxxxxxxxxxx>    wrote:
>>>> On 21/01/2011 6:49 PM, Christopher Glaeser wrote:
>>
>>>>> The Radionics uses 2K EOLR for fire and 1K EOLR for alarm. The Vista
>>>>> uses 2K for both fire and alarm. I replaced all the 1K alarm EOLRs with
>>>>> 2K EOLRs and all the alarm sensors are now functioning on the Vista.
>>
>>>>> The Radionics D2112 uses powered two-wire 2K EOLR on the fire zone, so I
>>>>> did not have to replace that resistor. However, the Vista 20P panel
>>>>> still indicates a fault on the fire zone (The Radionics did not report a
>>>>> fault prior to removal). I have checked polatiry (positive on 8,
>>>>> negative on 9) and tested voltages at the panel, at the smoke, and
>>>>> across the EOLR. All are 13+ VDC. The resistance of the fire circuit is 2K.
>>
>>>>> There are two fire devices wired to the panel. One is a System Sensor
>>>>> 2100TD smoke and the other is a Potter VSR-SF waterflow alarm.
>>>>> Four-conductor fire wire runs from the panel to each fire device,
>>>>> red/black powered outgoing and blue/brown return. The return pair of the
>>>>> first is wired to the outgoing of the second. The second return has a 2K
>>>>> EOLR.
>>
>>>>> Question: Are these two fire devices compatible with the Vista 20P?
>>
>>>>> Best,
>>>>> Christopher
>>
>>>> I seem to recall you have to cut a jumper in the Vista 20 for zone 1 to
>>>> be a supervised fire circuit.  Mind you, my memory could be faulty.  :-)
>>
>>> That supervises the siren circuit
>>
>> YKB.  What I said...  Memory's not what it used to be...  :-)
>>
>> --
>> Frank Kurzwww.firetechs.net
>
> Jesus Frank, who does the colors on your website?

Crayola... LMAO

Jim Rojas
Technical Manuals Online!
http://www.tech-man.com
8002 Cornwall Lane
Tampa, FL 33615-4604
813-884-6335