Re: 2-wire firewolf blinking

["Robert L Bass" <RobertLBass@xxxxxxxxxxx>]

"Total nerd" wrote:
>
> Hi.  I have a 2-wire firewolf that blinks green on
> those two LEDs every few seconds... but then
> it blinks red a couple of times, then goes back
> to green.


Napco says they should only flash green (normal)
or red (needs cleaning or service).

"In normal condition both LEDs flash Green.  When
the sensitivity drifts outside of its sensitivity limits,
both LEDs flash Red (e.g., when the unit needs
cleaning).  In the alarm state both LEDs are on
Red continuously.  When the condition exists as
stated above, the device needs to be cleaned or
returned to the factory for servicing."

You should try doing a more thorough cleaning of the
sensing chamber.  The air shot only blows out loose
dust.  It doesn't remove deposits which can form on
the inside of the chamber.

If that doesn't work and it's still in warranty I can get
it repaired or replaced for you.  If not, just replace it.
The FW-2 is fairly inexpensive, around $36 retail.

--

Regards,
Robert L Bass

==============================>
Bass Home Electronics
4883 Fallcrest Circle
Sarasota · Florida · 34233
http://www.bassburglaralarms.com
Sales & Tech Support 941-925-8650
Customer Service 941-870-2310
Fax 941-870-3252
==============================>