Re: Addin RP3-DGTL keypad to Napco 816

[Total nerd <geekboy0001@xxxxxxxxx>]

OK thanks.  So, the only "hardware" modification I have to do is to
properly set the jumpers in Keypad #2.  There is no weird keypad
combination I have to type-in or some strange jumper on the panel,
like the 3200 and 9600 have, right?
I can easily go into the PC Loader and add a second keypad to Area 1.
Thanks much


On Jun 18, 7:54=A0pm, "Bob La Londe" <nos...@xxxxxxxxx> wrote:
> go into the keypad programming area and set each additional keypad to be i=
n
> the area where you want it... ie area 1.
>
> "Total nerd" <geekboy0...@xxxxxxxxx> wrote in message
>
> news:f38db969-0c45-4dd5-bfff-b3117fbd9122@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> I have access to the PC loader if that's what you mean. =A0I know how to
> add/remove devices, configure zones, etc... I've just never added a
> keypad.
>
> On Jun 18, 7:32 pm, "Russell Brill" <russwbr...@xxxxxxxxxxxxx> wrote:
>
>
>
> > Nope......... The P816 must be configured to accept the second
> > keypad......
> > You'll need access to Installer Level programming in the P816 to enable
> > the
> > second keypad.....
>
> > "Total nerd" <geekboy0...@xxxxxxxxx> wrote in message
>
> >news:5baf8791-adab-4d5a-a548-24d3a248de2f@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx=

>
> > >I want to add a second RP3-DGTL keypad to a Napco 816 panel. All I
> > > have to do is tie it into the 4-line bus and set the jumpers in the
> > > back of the keypad to the second pad? That's it?
> > > Thanks!- Hide quoted text -
>
> > - Show quoted text -- Hide quoted text -
>
> - Show quoted text -