Re: NX8- V2 not uploading

["alarman" <nospam@xxxxxxxx>]

Russell Brill wrote:
> "alarman" <nospam@xxxxxxxx> wrote in message
> news:M8xMj.11159$CO2.6174@xxxxxxxxxxxxxxx
>> Russell Brill wrote:
>>> It's sad, the NX-8 used to be a good panel before GE got their hands
>>> on it...
>>
>>
>> How did they change it? What's different?
>
> If I remember right the original NX-8's had a large heat sink for the
> power supply, I believe that's gone now. Onboard clock doesn't work
> very well, sometimes the VER2 panel picks the day and time it wants
> to send a Test signal. The last NX-8 I used, I programmed two motions
> for Cross Zone activation, after doing that the panel decided not to
> send zone restorals anymore. I believe there was a service bulletin
> about some programming problems with Open/Close reports and some
> other feature. If you programmed for Open/Close and something else (I
> can't remember, old age), it caused something else to NOT work
> correctly. It sounds to me like a Firmware issue, you know cheaper
> and better :-)) And finally, they're using a CHEAPER enclosure, if
> you use a tamper switch, you must also use screws to hold the panel
> door shut... Ughhhhhhhhhhh....... You know, just little shit to piss
> off the installation guy and save GE some cash...
>> --
>> js
>>
>> He who laughs last.......thinks the slowest

Thanks. I didn't know.

--
js

He who laughs last.......thinks the slowest