Re: Intellisense FG-730 on Napco P3200

["Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx>]

the fg-730 is latchable



--
Crash Gordon
-------ouch------

<I feel like I'm diagonally parked in a parallel universe>
"jewellfish" <jewellfish@xxxxxxxxx> wrote in message
news:1190409637.978199.15860@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
| On Sep 21, 12:13 am, "t nguyen" <tnmissi...@xxxxxxxxx> wrote:
| > Hello, I have installed a FG-730 on Napco p3200 with the following
| > parameters
| >  NC loop with default 750ms response.
| >  programmed zone as 24 hr zone
| >  did not connect any wires to the tamper terminal
| >
| > Everything was looking fine until I tested that glassbreak sensor with
C&K
| > simulator.  The alarm went off as expected but after I disarmed the
system,
| > the panel was still in alarm condition on the glassbreak zone.   The
keypad
| > displayed as system ready but the siren still went off.  Not sure what
is
| > going here.  Could it be bad FG-730 or I did not program the panel
| > correctly?  I tried to change the zone type to a normal burg zone (not
24
| > hr) then it was ok.
| >
| > Thank you for your help
|
| You may check--some glass breaks (most) can be set to latch or not
| latch.  If it is you will need to reconfigure or hook it up to
| resettable VDC on panel.
|
| Cheers,
|
| Bill
|