Re: 4208U

[Jim <alarminex@xxxxxxx>]

On Jun 14, 9:51?pm, "Mark Leuck" <m..le...@xxxxxxxxx> wrote:
> <jabra...@xxxxxxxxxxxxx> wrote in message
>
> news:1181827417.289041.188160@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>
>
>
>
>
> > Hi, Two Ademco problems:
>
> > I connected a 4208U to a Vista 50ADT Panel.  What should the zone type
> > be for the 4208 (zones 10-16).  I tried "07" - referenced by DIP
> > switch, and all the zones (which have the 10K resistors) come up as
> > fault zones, with an addition zone 97 as a fault zone (based upon the
> > 4208 faulting).  I do not have a resistor on the "A" zone which is not
> > used when you use zones 9-16.  Resistance (before power applied comes
> > up at approx. 9.8 K on my DVM (so I have the right resistors in).
> > Each zone is homerun to a single window that has foil.  Is their an
> > EOL that connects accross the polling loop, as the manual shows a
> > picture of something coming out of the right side of the first 4208U
> > (or is that just a symbol to mean protection zones)?  I also set the
> > zones up with the same protection zone as the first 9, and as a
> > perimeter zone (03).  On the 50P panel, I used 24 as + and 25 as -,
> > however, why is there a "+" sign under pin 25?
>
> <sigh>
>
> > The second problem is that I wanted to change the default access code
> > from 1234 to ABCD (meaning 4 different numbers).  Somehow I also
> > changed the installer default code from 6*** to ABCD (my new security
> > code).  How do I change the installer code back to 6*** and leave the
> > security code unchanged?  Life was so simple using the Ademco 100
> > series (a battery and 3 little relays (no electronics in the panel).
>
> Obviously you should go back to an Ademco 100 judging by your post-



Hey ..... ya know ....... that would answer the CID versus 4/2 format
problem also.   :-)