Re: Honeywell 5878 Wall Mounted Keyfob

["Mark Leuck" <m..leuck@xxxxxxxxx>]

"Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx> wrote in message
news:466caa93$0$10298$815e3792@xxxxxxxxxxxxxxxxx
> It will be sweet once i have it programmed correctly.
>
> also read your other post.
>
> So my problem is I was doing it manually rather than the Sync method?

Well you could do it that way but you'd have to set it up for standard mode,
it's encrypted by default

1. Enable by holding STAY, 1 and 2 buttons for 3 seconds (LED flashes green)
2. Learn buttons like standard 5804 keyfob (Sensor type "BR")

> bummer is I don't have it with me now..it's at the client's house...so Im
> gonna have to fully understand it before I go back out...and there's no
SNI
> or phone line there yet so I cant Compass it.

I don't think you can Compass an encrypted device, it has to be synched
somewhere in the process or you get nothing

> It is freekin rocket science!

Yea try telling that to youknowwho, he can talk anyone through it in 3 hours
or so, they either learn or fall asleep on the phone

> Basically what I did was manually add zones 49-56 and configured them the
> way I wanted - no problem...I think?? But in adding the codes and auth  is
> where I ALWAYS get messed up with 5804x.  Added code 15 for serial 1 and
> code 16 for serial 2 and they worked manually (from the 6150) then went
back
> and tried to add the auth #4 thing for each code and that only made serial
1
> disarm key work, no other button would work.

Now thats strange, if you did it wrong no button would work

After you added the codes did you assign them?

1. Master Code + 8 + User (02 to 32) + # + 4
2. Enter 1st keyfob Zone (Example Zone 53)