Re: Oil Refinery

[Jim <alarminex@xxxxxxx>]

On Jul 20, 8:14?pm, "Just Looking" <nos...@xxxxxxxxxx> wrote:
> Well I thought of that. Bosch Gen 3 cameras had a pressurized model we used,
> but I haven't gotten a good answer from the rep on a Gen 4 equivalent model.
> I was going for at least one VG4-524-ETE1R model. I was not worried about
> "needing" explosion proof housing since I don't think it would be an issue
> (with the Aiphone LED and maglocks and strikes etc already there) in the
> area of deployment. However if there was an accidental release of something
> nasty from the refining area, without a pressurized dome the gas could enter
> the sensitive areas of the camera dome and cause problems.
>
> "Nick Markowitz Jr." <nick-markow...@xxxxxxxxxxx> wrote in messagenews:s5coi.60$ib7.9@xxxxxxxxxxx
Ummmm ..... just because there are other devices in the area that are
not rated as explosion proof, doesn't mean that they were installed
legitimately. I'd check anyway.

I've never installed any of that type of equipment, but I can't tell
you how many times I've found non plenum cable in plenums. I'll always
tell the client that there'll be additional cost for plenum wire, and
if they say to install otherwise, I make them sign a waiver that they
were informed or .... it's in the estimate that they sign off on, that
the installed wire is non-plenum, by customer request.