Re: Gemini P3200 - * ZONES FAULTED ***

["Mark Leuck" <m..leuck@xxxxxxxxxxx>]

Sounds like the quick programming and not advanced

"Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx> wrote in message
news:45984330$0$3576$815e3792@xxxxxxxxxxxxxxxxx
> Also:
> "I tried erasing the dealer program (4091), __but that did not help.__
> When I reset the system, I receive the prompt for RF Transmitter points
> and Key Fob Transmitters"
>
> Sounds like programming to me...but then again I hate programming Napco
> stuff.
>
>
> "Don" <don@xxxxxx> wrote in message
> news:91Xlh.15577$641.9957@xxxxxxxxxxxxxxxxxxxxxxxxx
> |
> | "Robert L Bass" <robertbass1@xxxxxxxxxxx> wrote in message
> | news:j9-dnaRxm9D5pQXYnZ2dnUVZ_tmknZ2d@xxxxxxxxxxxxxx
> | >> Have you been into the programming mode?
> | >> You may have pushed the wrong button in
> | >> programming.
> | >
> | > Based on his first post, the problem apparently came up prior to any
> | > attempts to reprogram the alarm.
> |
> | quoted directly from OP
> |
> | "Although, I am not sure if it caused the
> | problem, this condition seemed to occur after I tried to enable Chime 2
> | on these zones "
> |
> |
>
>