Re: Skylink SC001 Panel

["Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx>]

take a look at how they trip the optional voice dialer...maybe there's a dry
relay output for that.



<a50harrison@xxxxxxxxx> wrote in message
news:1158001588.566390.167090@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
|
| Crash Gordon wrote:
| > How about a relay off of the siren output terminals?
| >
| >
| > <a50harrison@xxxxxxxxx> wrote in message
| > news:1157994229.975441.149430@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
| > | Recently purchased a Skylink SC100 system thinking it would give a
| > | contact closure upon alarm to interface to another unit. This does not
| > | seem to be the case and the company says there is no easy "hack" to
the
| > | control panel to get a contact closure. Does anyone have or tried a
| > | solution for this. I can buy a an a/c unit to flash a silient alarm
and
| > | modify that, but would rather not have to spend the extra money to do
| > | this. Thank you
| > |
|
| Not sure if I measured that point right but showed about 14 volts DC at
| that point until it goes into alarm and then it drops to about 10
| volts. Did not disconnect the piezo buzzer and take a measurement, will
| try that next..had thought about this point as possible point to break
| into the circuit but do not understand the constant voltage on that
| point
|