Re: Skylink SC001 Panel

[a50harrison@xxxxxxxxx]

Crash Gordon wrote:
> How about a relay off of the siren output terminals?
>
>
> <a50harrison@xxxxxxxxx> wrote in message
> news:1157994229.975441.149430@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> | Recently purchased a Skylink SC100 system thinking it would give a
> | contact closure upon alarm to interface to another unit. This does not
> | seem to be the case and the company says there is no easy "hack" to the
> | control panel to get a contact closure. Does anyone have or tried a
> | solution for this. I can buy a an a/c unit to flash a silient alarm and
> | modify that, but would rather not have to spend the extra money to do
> | this. Thank you
> |

Not sure if I measured that point right but showed about 14 volts DC at
that point until it goes into alarm and then it drops to about 10
volts. Did not disconnect the piezo buzzer and take a measurement, will
try that next..had thought about this point as possible point to break
into the circuit but do not understand the constant voltage on that
point