Re: 15 sec dialer delay

["Don" <don@xxxxxx>]

">> >> > "Mark Leuck" <m..leuck@xxxxxxxxxxx> wrote in message
>> >> > news:me-dneIX27ZSb2TZnZ2dnUVZ_oednZ2d@xxxxxxxxxxxxxx
> So set up the panel to trigger an output on the Uplink then set the Uplink
> for 4/2 reporting. Closest trigger I can see is Alarm Memory
>
> It will do no good for Uplink to create a CANCEL signal since the alarm
> panel can't trigger an output specifically by a cancel. If you want to
> point
> fingers then it looks like GE

A job at GE would be ok. ;)

Thanks for your input.
Alarm memory....hmm....hadn't thought of that one.  But that would signal an
alarm not a disarm after alarm, right?
I'm sure ?? the NX 591 digital is in the works which will eventually fix
this cobbled up digital cell backup solution. But for now the auto cancel
and the no dialer delay of the NX8 appears to be better for this cobbled up
digital cell back up than the NX8V2 with the 15 sec dialer delay unless they
had cancel as one of the aux ouput triggers [which they don't].  Closest I
can see is "code entry" but that would send a signal any time the code was
entered and might cause additional expense for too many uplink signals
during billing cycle.