Re: DSC general system tamper code

["Jim Rojas" <jrojas@xxxxxxxxxxxx>]

Have someone on site go into programming through a keypad and press 903.
Wait one minute, then exit programming. That should clear your problem.

Jim Rojas


<cel@xxxxxxxxxx> wrote in message news:Z9Cdnfd--YF-tofZRVn-vA@xxxxxxxxxxxxxx
> How do I get rid of "general system tamper" code on a DSC 864? I used the
> DSC windows software to read the status I this code is set along with TLM
> and Low Battery. The status on the keypad only shows general system tamper
> as the only fault. I tried clearing out the latch error with the software
> but they still show up on the status rpt on the PC. I am not using a phone
> line yet and have disable TLM in the configuration. I don't have a bell
> connected, so I added a 1K resistor across the bell contacts. These
> changes
> got rid of my TLM and Bell trouble codes, but not the general system
> tamper?
>
> cel
>
>