Re: Power 832 issue

["Stanley Barthfarkle" <sbarth@xxxxxxxxx>]

you have programming issues. i would default it and start from scratch-




"user" <user@xxxxxxxxxx> wrote in message
news:lIidnaB1De_f_0fenZ2dnUVZ_tKdnZ2d@xxxxxxxxxxxxxx
>I installed this thing years ago, then had some trouble with it, so I left
> it dormant.
>
> I'm trying to get it up and running again.  Most things seem to work, but
> I'm having trouble with 2 items.
> -4 wire smoke detectors.  I have 4 ESL 449CT detectors with a DSC RM-1C
> power supervision relay at EOL.  The 5600 resistor is installed, too.  The
> problem is that the loop is not powering up.  I've hooked positive to Aux+
> as recommended, and hooked negative to PGM2.  I get no power.  I put a
> multimeter on the contacts and it confirms no power. I'm also getting a
> wiring fault on zone 7 (I've designated it as delayed Fire)
> I removed the power supervision unit and hooked the detectors up to Aux+
> and
> Aux- and the loop powers up fine.  I get the LED blink every 9 seconds
> from
> the detectors as normal.
> I accidentally put the power supervision unit back on the EOL while still
> hooked to Aux+ and Aux-.  The system worked for ~7 seconds and the system
> went off.  I disconnected the power supervision unit, unplugged the
> system,
> disconnected the battery, then re-atached power.  Everything came back up
> fine.
> Since I know that Aux+ is working, it must be an issue with PGM2.  Is this
> a
> programming issue and PGM 2 just isn't activated?
> Secondly, I've designated zones 5 and 6 to be interior zones (beams)  I
> don't want them activated during 'Stay' mode.  But, when I hold 'Stay'
> down
> to activate it, it runs a system test. (??)  How do I get this key back
> and
> working the way it should?
>
> TIA,
>
> Dave
>
>