Re: Programming Power632 for ContactID reporting

["Mark Leuck" <m..leuck@xxxxxxxxxxx>]

You posted the best reason to switch on auto CID, then it becomes just like
SIA and the signal is correct regardless of what you put in a location

"petem" <petem001@xxxxxxxxx> wrote in message
news:AESDf.42002$rX.485847@xxxxxxxxxxxxxxxxxxxxxx
> oups!!!
>
> lets check in the manual........
>
>
>
> Contact ID
>
> Contact ID is a specialized format that will communicate information
>
> using tones rather than pulses. This format allows more
>
> information to be sent faster than other formats. For example,
>
> in addition to reporting an alarm in zone one, the Contact ID
>
> format will also report the type of alarm, such as an Entry/Exit
>
> alarm.
>
> If the Contact ID uses Programmed Reporting Codes
>
> option is enabled, a two digit number from Appendix A must
>
> be entered in programming sections [320] to [353] for each
>
> event to be transmitted. The two digit number determines the
>
> type of alarm. The panel will automatically generate all other
>
> information, including the zone number.
>
> If the Contact ID uses Automatic Reporting Codes option is
>
> enabled, the panel will operate as follows:
>
> 1. If an event's reporting code is programmed as [00], the
>
> panel will not attempt to call the central station.
>
> 2. If the reporting code for an event is programmed as anything
>
> from [01] to [FF], the panel will automatically generate
>
> the zone or access code number. See Appendix A for a
>
> list of the codes which will be transmitted.
>
> NOTE:If the Automatic Contact ID option is selected, the panel
>
> will automatically generate all zone and access code numbers,
>
> eliminating the need to program these items.
>
> If the Contact ID uses Programmed Reporting Codes
>
> option is enabled, the panel will operate as follows:
>
> 1. If an event's reporting code is programmed as [00] or [FF],
>
> the panel will not attempt to call central station.
>
> 2. If the reporting code for an event is programmed as anything
>
> from [01] to [FE], the panel will send the programmed
>
> reporting code.
>
> Additional Notes on Contact ID
>
> 1. Account numbers must be four digits.
>
> 2. All reporting codes must be two digits.
>
> 3. Substitute the HEX digit 'A' for the '0'.
>
> 4. To prevent the panel from reporting an event, the reporting
>
> code should be programmed as [00].
>
> Please refer to Appendix A: "Reporting Codes"for a list of
>
> Contact ID Identifiers.
>
> Contact ID Uses Programmed/Automatic Codes . . [381]: [7]
>
>
>
> Sorry for the wrong info... ;-)
>
>
>
> and sorry Mark..
>
>
>
>
>
> "alarman" <alarman2000@xxxxxxxxx> a écrit dans le message de news:
> SxLDf.24336$jR.2839@xxxxxxxxxxxxx
> > "petem" <petem001@xxxxxxxxx> wrote in message
> > news:1vIDf.41764$rX.374879@xxxxxxxxxxxxxxxxxxxxxx
> >> there is no auto cid in power 832,in power 864 yes..
> >
> > It's a 1555 (Power 632) Not 832.
> > js
> >
> >
>
>