Re: Strange

["Matthew Stanley" <armorsecsys@xxxxxxxxxxx>]

Ok...well, I might have messed it up anyways....Im moving into a house I
bought and I had some Ademco wireless devices here in the house installed
with a Vista 50P. I took the system out an installed a hardwired system.. I
had that old vista 10 E board laying around so I thought I would put it in.
System is very small   3 doors and 1 motion.

I wanted to have it working so when people look to buy, they see that it
works.

I did something in programing and I couldnt get out so I shut it off... Now
the master code does not work. Now when I power the board up, its in the Arm
state and I cant get into programming. I tried connecting with a downloading
computer but it wont pick up...   * plus # does not work during power up
since its armed....

Anyone any ideas on how to fix my booo boooo?

I have an ADT Vista 20 here... I might install it.. but I wanted to use the
10 because if the new people wanted service, I could just call it up to
program...


Matthew

"Robert L Bass" <robertbass1@xxxxxxxxxxx> wrote in message
news:wsWdnQvMWpTc6hXYnZ2dnUVZ_q-vnZ2d@xxxxxxxxxxxxxx
>> Addition of new 5800 series transmitters with
>> this control panel is prohibited, other than for
>> repair of existing installations. Non-permitted
>> use voids U.S. warranty.
>
> If the panel is that old, the warranty has long since expired anyway.
> However, they wrote that because 5the 5800 series receivers were not
> compatible with the older panels.  Whether the current 5800 receivers will
> work with it is another question.  I don't know for sure thoiugh I suspect
> the answer is no.  If jno one tells you for sure by morning, I'll ask my
> Honeywell rep.
>
> --
>
> Regards,
> Robert L Bass
>
> =============================>
> Bass Home Electronics
> 941-866-1100
> 4883 Fallcrest Circle
> Sarasota · Florida · 34233
> http://www.bassburglaralarms.com
> =============================>
>