Re: DSC 832 #4 FTC Error

["Jim Rojas" <jrojas@xxxxxxxxxxxx>]

Yes, it should. Send a signal and see what happens. If it doesn't go away,
power cycle the panel and try again.

Jim Rojas


"Joe Nortman" <jnortman@xxxxxxxxx> wrote in message
news:RB9Dg.5834$Gv.1122@xxxxxxxxxxxxx
> Thank you very much.  I take it that change will also then clear my
> trouble light?
>
> Joe.
>
> "Jim Rojas" <jrojas@xxxxxxxxxxxx> wrote in message
> news:ao7Dg.11577$Pc.10979@xxxxxxxxxxxxxxxxxxxxxxxxxx
>> Change the reporting format to pager format in section 360. It will dial
>> once, then stop. No more com failures.
>>
>> Jim Rojas
>>
>>
>> "Joe Nortman" <jnortman@xxxxxxxxx> wrote in message
>> news:_27Dg.5823$Gv.5118@xxxxxxxxxxxxx
>>> Guys,
>>>
>>> I was about to setup my system with an alarm monitoring company and just
>>> to test I put my cell number in and entered a duress code to test if it
>>> worked. The system worked, called me on my cell and I hung up.  Well,
>>> the sucker kept calling me back and I finally had to turn off my phone.
>>> No big deal because it stopped after a while except my keypad now keps
>>> coming up with a FTC error.  I have the manual but I'm missing on how to
>>> clear this error.
>>>
>>> If someone can maybe point me to a page in the manual I will try to
>>> figure it out.....I just can't seem to find it.
>>>
>>> Thanks, JOoe.
>>>
>>
>>
>
>