Re: DSC Communications trouble -

["SF9026" <sf9026@xxxxxxxxxxx>]

also i forgot   you have pager format on there  you can use

"SF9026" <sf9026@xxxxxxxxxxx> wrote in message
news:H1m1f.24817$RZ6.161097@xxxxxxxxxxxxxxxxxxxxxx
> the only way to get the error code removed from the panel is going to be
> when it succesfully communicate    so you need to do a power down and
> power it back up    and until next communication error it will remain  ok
>
> you can disactivate   tlm  and communication  in section 380    light 1
> has to be off  to turn off comminication
>
> "wilsonbradley@xxxxxxxxxxxxxxxxxx" <wilsonbradley@xxxxxxxxx> wrote in
> message news:1128651753.183485.301930@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>> have a  DSC632 Alarm. I have the alpha/num LCD pad (LCD5500z). I do
>> not have CAT5 as my phone network. Only the older style (4wires REd,
>> green, yellow, black) 2 line cabling.
>>
>> I am somewhat familiar with the programing and have the service manual
>> and unpublished service codes.
>>
>>
>>
>> All my phone jacks in the house are live with Vonage. However, The
>> alarm still gives me a constant yellow light and error code.
>> communications Phone line
>> Trouble code on the LCD pad.
>>
>>
>> By the way, I am not using a monitoring service anymore. (ADT)
>> I would like the Alarm to notify myself when an event is tripped. I had
>> it set up this way before when I had ADT. It called them and myslef on
>> my cell phone. When a call came from home, I knew it was the alarm
>> because no one else would call me from there. I didn't get any result
>> codes because it was not setup in any useful format other than for ADT.
>>
>> 1.)Is there a way to reset the alarm.
>> 2.)Is there a way to make the alarm NOT look for a dial tone.
>>
>> Thanks so much
>>
>
>