Re: DSC Communications trouble -

["SF9026" <sf9026@xxxxxxxxxxx>]

the only way to get the error code removed from the panel is going to be
when it succesfully communicate    so you need to do a power down and power
it back up    and until next communication error it will remain  ok

you can disactivate   tlm  and communication  in section 380    light 1  has
to be off  to turn off comminication

"wilsonbradley@xxxxxxxxxxxxxxxxxx" <wilsonbradley@xxxxxxxxx> wrote in
message news:1128651753.183485.301930@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> have a  DSC632 Alarm. I have the alpha/num LCD pad (LCD5500z). I do
> not have CAT5 as my phone network. Only the older style (4wires REd,
> green, yellow, black) 2 line cabling.
>
> I am somewhat familiar with the programing and have the service manual
> and unpublished service codes.
>
>
>
> All my phone jacks in the house are live with Vonage. However, The
> alarm still gives me a constant yellow light and error code.
> communications Phone line
> Trouble code on the LCD pad.
>
>
> By the way, I am not using a monitoring service anymore. (ADT)
> I would like the Alarm to notify myself when an event is tripped. I had
> it set up this way before when I had ADT. It called them and myslef on
> my cell phone. When a call came from home, I knew it was the alarm
> because no one else would call me from there. I didn't get any result
> codes because it was not setup in any useful format other than for ADT.
>
> 1.)Is there a way to reset the alarm.
> 2.)Is there a way to make the alarm NOT look for a dial tone.
>
> Thanks so much
>