[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: Napco Gemini P800

Subject: Re: Napco Gemini P800
From: "Jim Rojas" <jrojas@xxxxxxxxxxxx>
Date: Fri, 21 Oct 2005 12:24:18 GMT
Newsgroups: alt.security.alarms
References: <kJY5f.829$8W.325@xxxxxxxxxxxxxxxxxxxxxxxxxx>

The eprom has 8 pins. The ATMEL chip sounds right, depending on the board
version. Did you try defaulting the panel?

Power down panel
Place a jumper from terminal 3 & PGM
Power up panel
Keypad will beep 3 times within 30 seconds I think.
Power down panel
Remove jumper
Power up and test...

Jim Rojas

"Stanley Barthfarkle" <sbarth@xxxxxxxxx> wrote in message
news:kJY5f.829$8W.325@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>I have an older, non-functional P800 board, and a newer, locked out P800
>board. (Ebay purchase) If I knew for sure which chip was the EEPROM, could
>I swap them and gain access to programming? The one I suspect to be the
>EEPROM is labeled "Atmel034".
>
> Thanks.
>

References:
- Napco Gemini P800
  - From: Stanley Barthfarkle

Prev by Message: Re: Residential grade door controllers
Next by Message: Re: Compass Software
Previous by thread: Napco Gemini P800
Next by thread: DSC PC1565
Index(es):
- Message
- Thread

alt.security.alarms Main Index | alt.security.alarms Thread Index | alt.security.alarms Home | Archives Home