Re: NAPCO NO LONGER REPLACING KNOWN DEFECTIVES

["Mark Leuck" <m..leuck@xxxxxxxxxxx>]

"Russell Brill" <russwbrill@xxxxxxxxxxxxx> wrote in message
news:9tn%e.5654$oc.4965@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>
> "Mark Leuck" <m..leuck@xxxxxxxxxxx> wrote in message
> news:MMydnSHFs_73ZKDenZ2dnUVZ_tOdnZ2d@xxxxxxxxxxxxxx
> >
> > "Russell Brill" <russwbrill@xxxxxxxxxxxxx> wrote in message
> > news:1Bl%e.5185$zQ3.555@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> >> Bob,
> >>
> >> When programming any of the Napco Gemini panels to use Ademco Point ID,
> > what
> >> value do you enter in locations like keypad Panic... Is it like the old
> >> Moose stuff, enter any value in the reporting location to enable
> >> reporting
> >> in Point ID, leave blank if reporting is NOT desired... Regards, Russ
> >
> > You can enter anything for reporting other than zones
> >
> >
> I know I must choose Burg, Fire, Heat, Gas, etc. etc... when it comes to
the
> zones... The manual is a little confusing when it comes to sending things
> like "Keypad Panic", there isn't a Point ID choice available... Soooo, I'm
> assuming if I enter any value (Like "11"), the panel will send a E120
signal
> to the CS... If I don't want to send a "Keypad Panic", I would leave that
> entry blank........ Mark is this correct???
>
> Regards,
> Russ

That is correct