Re: NAPCO NO LONGER REPLACING KNOWN DEFECTIVES

["Russell Brill" <russwbrill@xxxxxxxxxxxxx>]

After reading your response and the others, the Light Bulb above my head
came on.......... :-)) Thanks, Russ

"Robert L Bass" <robertlbass@xxxxxxxxxxx> wrote in message
news:g6WdnVSfK9ZIm6PeRVn-pg@xxxxxxxxxxxxxx
>> I know I must choose Burg, Fire, Heat, Gas, etc. etc... when it comes to
>> the zones... The manual is a little confusing when it comes to sending
>> things like "Keypad Panic", there isn't a Point ID choice available...
>
> That's because Napco uses predetermined CID codes for everything but the
> zones.
>
>> Soooo, I'm assuming if I enter any value (Like "11"),
>> the panel will send a E120 signal to the CS...
>
> You can enter anything at all or nothing at all.  If the CS has been
> assigned to use CID the panel ignores those data entries.  It only cares
> what you select for the zones (Burg, Fire, etc.).
>
>> If I don't want to send a "Keypad Panic", I would leave that entry
>> blank........ Mark is this correct???
>
> No.  That is not correct.  If you don't want keypad panic to be sent to
> the CS, uncheck the reporting boxes for that function for each CS number.
>
> --
>
> Regards,
> Robert L Bass
>
> =============================>
> Bass Home Electronics
> 2291 Pine View Circle
> Sarasota · Florida · 34231
> 941-925-9747 Sales & Tech Support
> http://www.bassburglaralarms.com
> =============================>
>