DSC 832 - General System Failure

[sixdoubleo@xxxxxxxxxxx]

I have a DSC 832 and am getting a a Trouble Code.  When I do a *2, the
Trouble code is "1" (Service Required).  Then I press "1" to get the
specific trouble condition and it says "3" (General System Trouble).
The manual describes this as:

"This trouble will be present if the PC5204 Power Supply Module has an
AUX failure, PC5204 Output #1 Trouble, or a printer connected to the
PC5400 Printer Module has a fault (off-line)."

I don't have a PC5204 or a Printer Module.  I have the stock DSC 832
with only an interior siren connected to the output.

FWIW, my alarm panel is located directly above my dryer in the utility
room.  Prior to this trouble code I noticed that when running the dryer
it would generate a trouble code, which would then go away when the
dryer turned off.  I figured the panel was sensitive to the high
humidity, heat,or moisture from the dryer.

Anyway, any ideas what the problem could be?  Did I fry the panel
maybe?  Battery problem?  Total coincidence?  Not sure where to go from
here.

I can provide further configuration specifics from here if needed.

Thanks!