RE: Possible pauses with xPLHAL

["Neil Wrightson" <neilw@xxxxxxxxxx>]

Hi Gregg,

My OSD is a RS232 device communication to xPLHAL via the xPLDEVCOM
component, so it does not know anything about port or remote-ip info.

I have an internal timer in my firmware that generates the heart beat. In
all other traffic I have seen using the xpl monitor in the manager, I have
not transmitted an extra heart beat.

Regards,

Neil Wrightson.


> -----Original Message-----
> From: Gregg Liming [mailto:gregg@xxxxxxx]
> Sent: Thursday, 21 July 2005 1:40 PM
> To: ukha_xpl@xxxxxxx
> Subject: Re: [ukha_xpl] Possible pauses with xPLHAL
>
>
> Neil Wrightson wrote:
>
> >Tony,
> >Not sure if this cut & paste will work or not but here goes.
> >
> >An example is at the end of this list but to save you some time
> >here are two consecutive messages.
> >Note the Date Time stamp and the OSD Time of each message.
> >
> >
> Neil,
>
>     I don't know if this is related to your problem, but isn't your
> device's heartbeat message lacking some info (port and
> remote-ip)?  That
> would definitely explain why you never got comms using mh's hub as it
> relies on the port info to know which port to rebroadcast on
> (for local
> hub listeners).  Also, from the log, I notice 2 in a row with
> the same
> time stamp--yet, the interval specifies 2 (minutes).
>
> Gregg
>
> ----------------------------------------------------------
> 20/07/05 17:32:15
>
> xpl-stat
> {
> hop=2
> source=nwe-mtlcd.123
> target=*
> }
> hbeat.basic
> {
> interval=2
> }
>
> ----------------------------------------------------------
> 20/07/05 17:32:15
>
> xpl-stat
> {
> hop=2
> source=nwe-mtlcd.123
> target=*
> }
> hbeat.basic
> {
> interval=2
> }
>
>
>
>
> xPL Links: http://www.xplproject.org.uk http://www.xplhal.com
http://www.xpl.myby.co.uk
To Post a Message: ukha_xpl@xxxxxxx
To Subscribe:  ukha_xpl-subscribe@xxxxxxx
To Unsubscribe:  ukha_xpl-unsubscribe@xxxxxxx