[Message Prev][Message
Next][Thread Prev][Thread Next][Message
Index][Thread Index]
Re: Multiple X-10 messages through W800
--- In ukha_xpl@xxxxxxx, "Mal Lansell" <mlansell@f...>
wrote:
>
> --- In ukha_xpl@xxxxxxx, "kirstglen1"
<glen.ferguson@o...>
> wrote:
> >
> > Hi,
> >
> > I'm finally starting to get the hang of xPL using the W800 and
> > Homevision. I am still having one small problem trying to run a
> > homevision macro where on pressing the X-10 button, xPL sends
> > four "macro do" commands to HV in response to 2 X-10
triggers
(with
> > only one button press). Homevision is then responding about 10
times
> > with confirmations. The problem is that the macro opens my gates
and
> > restarting it multiple times causes the gates to stop and start.
> > Thanks in advance for the help.
> >
> > Glen
>
> I need a bit more information...
>
> What are you using to send the X10 command (remote control? Which
> kind?). What command is being used to open the gates (A1-on etc)?
>
I'm using a remote control from marmitek, however a different remote
also does the same thing. I am sending a D2-on command which
triggers a HV macro that pulses an output. I tried doing this
directly but couldn't get it to work (I think through a poor
understanding of the syntax required)
> How many messages are being sent by the W800 in response to a
single
> button press?
two are being received by the W800 and four are being sent by xPL
>
> Mal
Thanks
Glen
xPL Links: http://www.xplproject.org.uk http://www.xplhal.com http://www.xpl.myby.co.uk
To Post a Message: ukha_xpl@xxxxxxx
To Subscribe: ukha_xpl-subscribe@xxxxxxx
To Unsubscribe: ukha_xpl-unsubscribe@xxxxxxx
xPL Main Index |
xPL Thread Index |
xPL Home |
Archives Home
|