[Message Prev][Message
Next][Thread Prev][Thread Next][Message
Index][Thread Index]
Re: Multiple Instances / Zoning Questions
- Subject: Re: Multiple Instances / Zoning Questions
- From: steve.cooper@xxxx
- Date: Fri, 19 Mar 2004 11:05:00 +0000
> I was hoping this could be done in xplhal.....how is this done ???
would
> certainly make it easier.......
> If done on the pic would it reply to a config.list as follows ?
Not sure how the syntax of the messages go but you could use an array based
config item like
group or filter is currently. So you just have a config item zone with
entries 1 to 8.
Tony/John can you advise how this get sent in the config message.
> Also if all probes status requested in a zone, then 6 seperate replys
> required ??one for each probe correct???
Correct one reply for each probe.
> The doc says when requesting a devices status
> current=request
> Should this not be command=request...?????? Doesnt the device reply
with
> current=...??
No the control.basic and control.zoned do not have an element call command.
The fact that it would be a control. schema dictates that the message it a
control request and therefore is requesting the current status.
> Is the following correct
Yes looks fine
> Sorry for all the Q,s
No problem ask away.
S.
___________________________________________________________________________
The information contained in this message is confidential and may be
legally privileged. If you are not the intended recipient, please do not
read, copy or otherwise use it and do not disclose it to anyone else.
Please notify the sender of the delivery error and then delete the
message from your system.
Any views or opinions expressed in this email are those of the author only.
Communications will be monitored regularly to improve our service and for
security and regulatory purposes.
Thank you for your assistance.
___________________________________________________________________________
xPL Main Index |
xPL Thread Index |
xPL Home |
Archives Home
|