The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

RE: xPL protocol questions


  • Subject: RE: xPL protocol questions
  • From: "Tony Tofts" <tony@xxxxxxxxxx>
  • Date: Fri, 30 Jul 2004 11:20:28 +0100

> Why only one? I thought that only applied to devices that
> supported remote config, but that couldn't store their instance.
> If a device doesn't support remote config (e.g. my Winamp
> plug-in) but can store it's instance elsewhere (e.g. in an
> INI file) there is no reason why you can't have multiple
> instances of the device.

I jumped to the conclusion that Gerry meant if it couldn't store it's
config, then it couldn't store an instance.

You're quite correct ;-)

> I'll check that this is mentioned in the protocol spec.
> Note that hbeat.end can also be used to signal a local hub
> that a device is terminating.

Good point

> > > 4) Do responses to a status request always have to have a
> > > target=* or can they choose to direct it at a certain target
> > > (presumably, the source)?
> >
> > Optional
>
> I thought it always had to be target=*?

Correct, my mistake.

> It's probably more a case of the protocol document not being
> as specific as it should be - I'll see about amending it when
> I get chance.

Thanks John.

Regards
Tony




xPL Main Index | xPL Thread Index | xPL Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.