The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: RE: Re: HV at UKHA2004?


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

RE: xpl newbie: cm12 interfacing with win98 questions


  • Subject: RE: xpl newbie: cm12 interfacing with win98 questions
  • From: Tony Tofts
  • Date: Thu, 06 Nov 2003 06:42:00 +0000

> You also need to have an xpl hub running (vb6 or .net).... And you
> need to configure the xplcm12, before it will listen

With win98 it will need to be the vb6 version of course

> Do you have xplhal yet?

Alternatively Ian could send you his gui sender (I think Steve has one too
that would do this) and send a config.response

Directed message

Source=vendor-device.instance
Device=tonyt-cm12u.default
Schema=config.response

Newconf=node
Interval=5
Filter=xpl-cmnd.*.*.*.x10.basic
Comport=<comport of cm12>

Should do the trick

Then send an x10 command...

Regards
Tony






xPL Main Index | xPL Thread Index | xPL Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.