The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: TSC.cmd / id



Ok, take your time.

Per

--- In xAP_developer@xxxxxxx, Kevin Hawkins <yahoogroupskh@...>
wrote:
>
> Hi Per,
>
>     I have spent some time today reading through the TSC specification
> and I too have some questions about it's implementation - bear with me
> whilst I progress this...  I haven't forgotten.
>
>     Kevin
>
> Per wrote:
> > Kevin,
> >
> > No worries, we all have real life stuff to handle :)
> >
> > Regarding the UID and subaddress; I would expect the UID to
extend to the subaddress; how elese do you address it with the UID in the
TSC.cmd block?
> >
> > Regards,
> >
> > Per
> >
> > --- In xAP_developer@xxxxxxx, Kevin Hawkins
<yahoogroupskh@> wrote:
> >
> >> Hi Per,
> >>
> >>     Haven't forgotten - just away from home a bit - and very
busy -
> >> should get some feedback on those TSC messages to you 
shortly -
> >> hopefully some others will too ...
> >>
> >>     I understand about the pin better now - as I assume the
'output' and
> >> the internal sensor might present different values they will
have to be
> >> two different endpoints, one an input and one an output  -
maybe as a
> >> hierarchical sub addresses
> >>
> >>        :output1.pin   and  :output1.sense
> >>
> >>     The xAP spec places some restrictions on the logical
address , I
> >> don't believe this extends to the sub address portion however
- maybe
> >> Patrick can confirm ?
> >>
> >> "As a consequence of the fact that the logical name
uniquely identifies
> >> a device (or software application), there are constraints
imposed on the
> >> allocation of logical names. If a device exists on the xAP
network with
> >> a logical name a.b.c, a second device may not use the logical
name
> >> a.b.c.d. "
> >>
> >>      cheers Kevin
> >>
> >> Per wrote:
> >>
> >>> The two-way I/O pin is a standard open drain I/O with
added internal sensor used in most ICs. See Figure 11 in http://datasheets.maxim-ic.com/en/ds/DS2406.pdf
> >>>
> >>> You're right of course regarding the BSC block; shamefull
I didn't get that right.
> >>>
> >>> // Per
> >>>
> >>>
> >>>
> >
> >
> >
> >
> > ------------------------------------
> >
> > Yahoo! Groups Links
> >
> >
> >
> >
> >
>




------------------------------------


xAP_Development Main Index | xAP_Development Thread Index | xAP_Development Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.