The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: Part P



When 12V halogens first came out they were often connected with up to
10 or so on one transformer. I think the problem then was that when a bulb
blew (which they invariably do relatively often) there could be a surge
which would cause other bulbs to fail too.

These days the transformers are electronically regulated (decent ones like
Osram anyway) to provide a soft start (which improves bulb life) and so may
not be so susceptible to surges. The convention still seems to be to have
multiple transformers, though depending on what size bulbs you use (and new
higher efficiency 12V bulbs use less power for the same light output) you
can quite happily share two or more fittings per transformer (I have 2 per
transformer in my kitchen ceiling, or 4 for cupboard 10W accent lights).

Finally you also want a transformer that you can get at, especially if the
floor above is occupied, typically through the fitting. Therefore that
limits the size (and so power output) it can be.

Note: I'm not a spark so much of the above is speculation ;-)


Simon

--- On Mon, 3/5/10, Mal Lansell <mal@xxxxxxx> wrote:


Oh, and now my rant is nearly done, can anyone explain why each 12V bulb

should have its own transformer?  It seems so wasteful.



Mal




















[Non-text portions of this message have been removed]



------------------------------------

<*> Join the Automated Home Forums
http://www.automatedhome.co.uk/vbulletin/


UKHA_D Main Index | UKHA_D Thread Index | UKHA_D Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.