c-bus and hot water/boiler control

[Kieran Broadfoot <kjb@xxxxxxxxxx>]

Hi there,

I am currently planning a c-bus installation and was prompted to consider
controlling an underfloor heating installation using clipsal thermostats. 
Single zone thermostats seem appropriate coupled with a 12ch relay unit to
control the manifold actuators but I am less sure how to drive hot water
generation from my boiler.  I am planning on installing a bosch system
boiler and unvented cylinder.  Has anyone trodden this path such that they
could provide some advice to me regarding configuration/cabling etc?  Did
you use an additional thermostat (or a zone on a 4-zone unit) to control
the circuit?

If anyone could provide some advice it would be very much appreciated.

All the best
kieran




------------------------------------

<*> Join the Automated Home Forums
http://www.automatedhome.co.uk/vbulletin/