The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

RE: Automating the press action of a momentary switch



Would you be able to take the device apart? If so, you could use any
of the relay output type controllers and wire (solder) into the device. Eg
using a xAP Netiom etc...

Paul.



> -----Original Message-----
> From: ukha_d@xxxxxxx [mailto:ukha_d@xxxxxxx] On Behalf
> Of noughtomate
> Sent: 03 December 2008 16:01
> To: ukha_d@xxxxxxx
> Subject: [ukha_d] Automating the press action of a momentary switch
>
> Hi,
>
> Are their any products on the market which allow you to perform a
> mechanical press action on a momentary switch ?
>
> It's the type of switch which performs an On or Off with the same
> button. e.g. Your PC or an AV device.
>
> I have a number of these types of devices which may be sensitive to
> removing the mains using Z-Wave, X-10 etc.. so I was hoping there may
> be some IR or IP controlled device to perform the finger press.
>
> Is there anything out there ?
>
> Thanks,
>
> Balraj
>
>
>
>
> ------------------------------------
>
> ********************************************
> Limited Time Offer - Free iPhone VAT Calculator
> http://berble.com/index.php/component/content/article/109
> ********************************************
>
>
>

------------------------------------

********************************************
Limited Time Offer - Free iPhone VAT Calculator
http://berble.com/index.php/component/content/article/109
********************************************


UKHA_D Main Index | UKHA_D Thread Index | UKHA_D Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.